Making pumice bits smaller
Making pumice bits smaller
I bought a 1/4-yard of composted mulch and pumice mix. Most of the pumice bits are too large for potted plants (see large pieces in the photo). Any thoughts on an expedient way to crush up the nodules? I've used a sledgehammer, but that takes forever, and it's a big job. I hate for it to go to waste.
Re: Making pumice bits smaller
You could put the large pieces in a heavy duty bag and run it over with your car. Sounds kind of funny but could work. I have not tried it. Could have adverse effects and crush them to powder, but worth a try. Or you could just save the large pieces to line the bottom of your pots. Good luck.
Re: Making pumice bits smaller
Beg, borrow, or steal a rock crusher from a sandpit, quarry, construction, or equipment rental place.
Or maybe you can just make one yourself.
https://www.youtube.com/watch?v=7eKXIoDaLWo
Or maybe you can just make one yourself.
https://www.youtube.com/watch?v=7eKXIoDaLWo
Re: Making pumice bits smaller
As I was in the building trade I use my old hand held earth rammer on a flat concrete surface to break down pumice etc, much easier than using a lump or club hammer, and a sledge hammer is overkill! Then I put it through a sieve or riddle (Bonsai riddle off EBAY) of the appropriate size and return the overlarge pieces under the rammer again. Your local builders merchant may stock them. See:-
https://www.wonkeedonkeetools.co.uk/ear ... th-rammer/
https://www.wonkeedonkeetools.co.uk/ear ... th-rammer/
Re: Making pumice bits smaller
Thanks everybody--all great ideas.
Re: Making pumice bits smaller
Blendtec blends, but it won't crush gold ore.
I'll bet one of these would do just fine.
This is only sort of a joke.
I'll bet one of these would do just fine.
This is only sort of a joke.
Re: Making pumice bits smaller
I know this is an old thread now, but I thought I'd update it with my solution. I tried running over a bag of pumice with my truck tire. This did not work at all. An 8-inch square handheld tamper crushed the pumice, but it took multiple attempts and was very tiring. Finally, I picked up a hand-crank meat grinder at a second hand store. Success! It definitely broke up the pumice nodules into smaller bits more suitable for cactus medium. It created quite a bit of dust that needed to be sieved out, but overall I was pleased with the results. It's not a quick process, especially if you have lot of pumice (ahem, two trash cans full ) but it's easy to get enough bits for a small-medium size potting project.
Re: Making pumice bits smaller
You could try and see if the sand sized dust is any good for seed raising if you have a few spare seeds you are not bothered about, or from off your own plants?
Re: Making pumice bits smaller
Yeah. Maybe I'll give it a try. I have used sieved calcined clay bits for seedlings with good success. The stuff I buy is used for baseball infields, but they also market it as aquatic plant soil, oil-dri, kitty litter (in some places), etc.
Re: Making pumice bits smaller
That sound like Turface.
Re: Making pumice bits smaller
Yes. Turface MVP. It's cheap! The local irrigation/landacaping supply store sells a 50 lb bag for about $15. The pumice/mulch mix is is even cheaper bought in bulk. It averages about $3.25 per 50 lb.